overlay safety repair
Started by kimsdad, Aug 17 2012 05:07 AM
6 replies to this topic
#2
Posted 17 August 2012 - 11:24 AM
I recently acquired an Italian Waterman overlay. Usually, the Waterman is easily repaired by removing the section above the knob. This pen's overly is seamless and cannot be unscrewed in the usual fashion. Does the overlay have to be removed or cut?
Jim
I have seen overlays with seams. I haven't as yet seen a seamless one, but I would remove the overlay rather than cut it. I know of repairman who routinely does this if you are unsure about doing it yourself.
#3
Posted 28 August 2012 - 12:46 PM
I have just recently repaired a pen of this type, it was not easy, basically gripping the overlay to squeeze the barrel end and then dismantle to repair. I installed viton "O" rings and tested the pen with out the overlay, before fully assembling with the overlay. A very bad design and not an easy task to carry out on pens that are normally fairly straight forward to repair.
Eric
Eric
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users